![]() Pulse when the current temperature exceeds the value set in parameter (Ssdϑ). ![]() On as long as drying and airing are active. On as long as sauna and drying phase are active. (e.g Child lock, cleaning)Ĭontrol via user interface is still possible. The name of the connected sensor is used in the user interface.ĭisables inputs (Tg), (Fan), (St) when On. If no presence is detected, the sauna will shutdown automatically after the duration set in parameter (Ssdt). If connected, the bench temperature is used as current temperature. The door state is only used for display in the user interface! The fan can only be switched on when the sauna is On.Īctivates the sand timer for the duration set in parameter (Std).Įach subsequent pulse on the input restarts the timer. Toggles between Sauna On, Heating, Drying, Airing, Sauna Off. You can set a range of Operating Modes for different sauna users with various comfort levels.With this Function Block a sauna can be optimally automated.Īll standard Sauna heaters can be controlled (switching of the heating elements, as well as analog control via 0-10 V signal).Īlso integrated in the module is an hourglass function, fan and post-drying, as well as a safety shutdown, if you forget to switch off the heater. Operating Modes: If your customer has a sauna heater with an evaporator, different operating modes can be achieved using steam or dry heat such as Finnish, Herbal, Steam Sauna, Dry Sauna and more. If the sauna is active, the e-charging station will become throttled. To avoid overloading, the Miniserver constantly monitors the total load. So there are two electricity consumers with large loads in the house. This is especially helpful for potential falls or overheating.Į-charging & load management: In the above project, an e-charging station is installed in the garage. Movement detection: As another safety feature, you can use motion sensors and configure the sauna to switch off if motion stops after a specific period of time. For example, a sauna that reaches an STL of 220✯ will stop electricity from running to the heater. A safety temperature limiter, or STL, is installed as a standard in every sauna in case of dangerously high temperature. ![]() Safety switch: The sauna has several safety measures. Integrate a fan or post-drying: In the example project above, these functions were not used because the sauna included a window. Then after 15 minutes have gone by, the light in the shower can switch on automatically. Sauna session activated (hourglass function): Lights inside the sauna can be programmed to turn on a specific color while the lights outside the sauna (e.g. This feature is helpful to keep in mind, knowing that the bench is usually fewer degrees Fahrenheit than what the temperature sensor reads on the ceiling. Temperature correction feature: Use parameter Tc of the function block to reach, for example, a temperature of 180✯ on the bench. At the location of each Touch point, a hole was drilled into the wall. Wall thickness is important to keep in mind while planning for built-in Touch Surface control. The temperature range suitable for Loxone Speakers can be found in our Datasheet.įor sauna operation, the Touch Surface is built into the wall of the sauna. ![]() Keep in mind the possible temperature ranges that you may reach in your sauna. The audio function in the sauna comes from built-in Loxone Speakers underneath the bench. The strips are also installed within an aluminum rail for protection from moisture and corrosion. They were installed under the bench to create a subtle glow. With a protection class of IP 20, this ensures that the silicone covered strips will not emit any odor from the heat. In this traditional Finnish sauna above, you see a wood-lined room with a modern touch of LED Strips. During the construction phase, make sure that there are sufficient cables leading from the distributor to the sauna for: First up is, of course, the sauna heater. This is controlled by using relays and contactors.
0 Comments
Leave a Reply. |